3-11 Down Pipe Installation
(1) Install three stud bolt on the turbine
housing as shown.
(Parts used #64)
(2) Check the fitment of the downpipe heat
shield and install gasket on the catalytic
converter end of the downpipe.
* The heat shield will be reinstalled later
once the downpipe is installed.
(Parts used #45, 48)
(3) Install the downpipe to the turbo using
provided gasket and hardware.
* Make sure that there is enough
clearance between the downpipe and
the oil pressure line.
(Parts used #3,44,64,65)
(4) Reinstall the catalytic converter and
reconnect the o2 sensor connectors.
* Reuse factory hardware to bolt the cat
back on but the bolts with springs will
require the provided nuts.
(Parts used #66)
• Heat Shield Installation
(1) Install the turbine housing heat shield on
to the downpipe using the provided M8 x
15mm bolts.
* Make sure that there is enough
clearance between the oil pressure line
and the power steering line.
(Parts used #47,61)
Commentaires sur ces manuels