3-14 e-Manage Installation
(1) Remove the cover under the glove box to access the ECU and ECU harness.
(2) Install the Grey wire to the e-Manage I/J Harness (18Pin) connector as shown
below.
(3) Install the ignition harness wires in the e-Manage I/G Harness (12Pin) connector
as shown below.
* When inserting the wires in to the connectors, make sure that the direction of the
pins are correct and push them in all the way until they click in.
PL
W
IG Harness connector 12P
I/J Harness connector 18P
(4) Connect the I/J and I/G Harness to the factory ECU harness as shown in the
diagram on next page.
(Parts used #15, 16, 17)
Important
• This installation should only be performed by a trained specialist who is very
familiar with the automobile’s electrical and fuel management system.
• GReddy Performance Products Inc. is not responsible for any damage to
the vehicle’s electrical system caused by improper installation.
• It is recommended to solder all wires and use electrical tape or shrink warp
to insulate the wire connections.
Commentaires sur ces manuels