GReddy Supercharger Kit 2000-2002 Toyota Celica GT-S (ZZT231) MP62 Supercharger kit ―1―
(3) Cut off the OE injector harness connectors and replace with Kit injector harness connectors. ※ ※ ※ ※ ※ Mark or label harness wires to
3-11 Kit Intake Tube Installation (1) Remove the studs on the OE intake air surge tank and screw them into the Kit intake tube. 〈Part №3
Bracket A Bracket B For Vehicles With Auto Cruise Control ① Place the rubber grommets removed in step 2-7 between the cruise control unit and
Harness GrommetGround A B 3-13 Kit e-manage Ultimate installation (1) Remove the ECM box cover and disconnect and remove connector A, B,
e-manage Ultimate Connector Harness Pin Location C B A ※ Viewing from wire harness side. Ultimate Pin № Signal (Color) OE ECM Pin № Sign
These wire are outlined in the e-manage diagram. These wires will not be used in this kit. Use electrical tape to cover the ends
(6) Route the e-manage ultimate wire harness safely though the engine bay and use cable ties to secure the harness and prevent it from moving. Pla
3-16 Starting the Engine (1) Install the radiator reserve tank to its original location and fill with coolant. Bleed the air from the cooling syst
Front Fender Apron & Dash Panel
Cylinder Head
SUPERCHARGER KIT Toyota Celica ZZT231(2ZZ-GE) Installation Manual Please read the manual carefully before installing and using this product. This
Suspension Cross Member and Under Cover
Switch and Relay
Air Cleaner
Fuel Injection System
Ventilation Hose
Cylinder Block
Manifold
1.Parts List 1.Supercharger MP62 (W/ Pulley) 1 2.Intake Manifold 1 3.Intake Tube 1 4.Tensioner Pulley 1 5.Supercharger Belt (6PK-2475) 1
Part List Diagrams/Pictures 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17,18 19 20 21 22 23 24~32 ―
2.OEM Parts Removal Please refer to factory repair manual for OE component removal guidance. 2-1 Safely remove pressure from fuel lines. (1) Re
3.Kit Install 3-1 OE ventilation Tube No. 1 Modification Remove the bracket from the ventilation tube in 2-13. Install back to same locati
3-3 Kit Supercharger assembly (1) Screw in the provided stud bolts onto the supercharger outlet flange and apply silicone sealant to the fl
Kit dipstick guide OE dipstick guide 3-5 Kit Oil Dip Stick Installation (1) Remove the O-ring from the OE dipstick guide and place it on the Kit dip
3-8 Kit V Ribbed Belt Installation. Adjust the tensioner pulley toward the front of the vehicle to adjust belt tension. 〈Part №5〉 VP :
Commentaires sur ces manuels