Greddy TURBO KITS: VW Golf 1.8T 2002-05 / TD04-19T Manuel d'utilisateur télécharger pdf (Page 13)

(8)

Install the factory drive shaft heat shield.

※ Use factory bolts.

※ Please check to make sure there is clearance

around the heat shield after installing.

3 – 6 Airinx and Suction Pipe Installation

(1) Install the ５０φ－６０φsilicone reducer hose

onto the turbo side of the suction pipe and

use a hose clamp to attach.

※ Remove the O-ring that is on the suction pipe.

※ Wrap the silicone hose with the provided

thermo cloth.

〈Parts № 26, 33, 34, 43〉

Fires may be caused from parts that

are not protected from extreme heat.

(2) Install the Airinx air pump adapter and

adapter hose onto the Airinx air filter

housing.

※ Take caution when installing the air pump

adapter. Do not cross thread.

〈Parts № 5, 6, 46〉

(3) Remove the one of the bolts on the back of

the Airinx housing.

(4) Install the Air flow meter onto the Airinx filter.

Install the 70-80 reducer onto the Air flow

meter and place the Airinx Adapter Pipe inside

the opposite end of the reducer. Install

whole assembly onto factory suction hose.

Connect the air pump feed hose to air pump

adapter on Airinx housing. Connect the Air

Flow Meter harness connector.

〈Parts № 7, 8, 27, 35, 36〉

※ Use factor hose band on factor suction hose.

※ Take caution as air flow meter is directional.

1 2 ... 8 9 10 11 12 13 14 15 16

Pas de commentaire

Greddy TURBO KITS: VW Golf 1.8T 2002-05 / TD04-19T Manuel d'utilisateur Page 13