2.Remove Stock Parts
Please refer to the manufacture repair manual for removing stock
components.
2-1 Disconnect the batter (-) terminal.
2-2 Remove the engine cover.
2-3 Remove the right side engine under cover.
2-4 Drain the engine oil and coolant fluid
2-5 Remove the compression tube heat insulator.
2-6 Remove any hoses or tubes from the air filter box to the turbo charger.
2-7 Remove the air box and intake hose Assy.
After, remove the waste gate bypass regulator valve and charge pressure bypass
valve from the intake hose.
Mark
Turbo sideRear
2-8 Remove the front exhaust pipe, 02 sensor, and
heat shield.
※ Mark the exhaust clamp before removing.
※ Be sure to separate the pre and post O2 sensors
to prevent improper installation order.
2-9 Remove the drive shaft protective heat cover.
2-10 Remove the turbo oil return pipe.
2-11 Remove the canister hose attached to an aluminum tube on the compressor inlet.
2-12 Remove the exhaust manifold.
2-13 Remove the turbo coolant supply feed and return lines.
2-14 Disconnect the oil supply line from the turbo center housing.
2-15 Remove the turbo charger Assy.
6
Commentaires sur ces manuels