Greddy TURBO KITS: Honda S2000 (AP2) 2004-06 / T518Z Manuel d'utilisateur télécharger pdf (Page 14)

―１４―

3-4

Oil Feed Line installation

(1) Install the #34 oil feed line as shown, connecting

one end to the ９０°fitting from the oil pressure

switch and the other to the union on the top side

of the turbo. Bend the line to make room for the

compression pipe on the turbo. Be careful not to

kink the line. Be sure that the oil line does not

make contact with any other parts.

〈Parts used: #34〉

(2) Remove the factory oil drain bolt and crush

washer. Using #41 Union and #42 brass washer,

install where the factory oil drain bolt was located.

〈Parts used: 41, 42〉

(3) Cover the #46 １５φhose with thermo cloth (#78)

and connect it from the oil return flange pipe to the

oil return union on the oil pan. Use #55 hose

bands on each end to secure the hose from

leaking oil.

〈Parts used: 46，55, 78〉

3-5 Downpipe Installation

(1) Disconnect and remove the O2 sensor from the

factor exhaust manifold and install onto the

provided downpipe. Install the #64 downpipe

gasket on the end of the downpipe, which

connects to the catalytic converter.

〈Parts used: 3，64〉

№41

№34

№64

Sensor

№46

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Pas de commentaire

Greddy TURBO KITS: Honda S2000 (AP2) 2004-06 / T518Z Manuel d'utilisateur Page 14