Greddy TURBO KITS: Toyota Celica GTS 2000-02 / MP62 Manuel d'utilisateur télécharger pdf (Page 11)

３－11 Kit Intake Tube Installation

(1) Remove the studs on the OE intake air surge tank

and screw them into the Kit intake tube.

〈Part №３〉

(2) Attach the Kit intake tube to the supercharger inlet.

At the same time, place the spacer between the Kit

intake tube bracket and “Thread A” on the picture

and use the M8 x 50mm bolt to secure the bracket.

Secure the other end of the bracket to the engine

block.

※

Use silicone sealant between the supercharger inlet

and intake tube flange. Prevent sealant from

protruding to the inside of the flange.

Torque bracket bolts starting from the engine.

Thread

Ａ

Spacer

Bracket spot

on engine

〈Parts №１２，１４，２６，２９，３１〉

３－12 OE Throttle Body Installation

(1) Place the OE gasket on the intake tube and install

the throttle body, water bypass hose, and electrical

connectors.

Re-use OE bolts and nuts. Please confirm that the

throttle body gasket is place properly also.

(2) Install the accelerator control cable.

For vehicles without Auto Cruise Control

Install the accelerator control cable bracket to the

intake tube using the OE bolts and install the

throttle cable to the throttle lever.

―１１―

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Pas de commentaire

Greddy TURBO KITS: Toyota Celica GTS 2000-02 / MP62 Manuel d'utilisateur Page 11