Greddy TURBO KITS: Scion xB 2003-05 / TF03-14G Manuel d'utilisateur télécharger pdf (Page 15)

3－

－－

－1

E-

-manage Installation

manage Installationmanage Installation

manage Installation

（1）Remove the cover under the glove box to access the ECU and ECU harness. Unplug the ECU connectors

from the ECU.

（2）Connect the provided Plug and Play e-manage harness to the ECU and ECU harness. Connect the

e-manage unit to the Plug and Play Harness.

〈Parts№34,35〉

(5)Secure the e-Manage next to the ECU.

* Avoid mounting the e-Manage unit in the area that would be exposed to direct sun light,

moisture, or near heater outlet.

-1

Starting the Engine

Starting the EngineStarting the Engine

Starting the Engine

(1) Refill the engine oil to factory spec.

(2) Check all the hoses and wires connection, then reconnect the negative side of the battery.

(4) Remove the ECM fuse and crank the engine to get oil pressure to the turbo. (Until the oil light

on the dash turns off) Check for any oil leaks, then reinstall the fuse and start the engine.

(5) While idling, check for any oil, coolant, or air leaks.

(6) After inspection, reinstall the under cover and other stock parts that were removed.

(7) On the initial run, be sure to have a boost gauge to check the turbo-actuator setting. This turbo

kit is preset to boost between 0.3kg/cm

to 0.4kg/cm

It is very important that you monitor the boost pressure, and make sure not to over boost. Over

boosting can cause engine damage.

This completes the Turbo Kit installation.

1 2 ... 10 11 12 13 14 15 16

Pas de commentaire

Greddy TURBO KITS: Scion xB 2003-05 / TF03-14G Manuel d'utilisateur Page 15