Greddy TURBO KITS: Nissan 240SX 1995-98 / TD06-20G Manuel d'utilisateur

GReddy Turbo Kit 96-98 Nissan 240SX S14 (KA24DE) TD06-20G 8cm2

3-5 Exhaust Manifold Installation 1. Install the exhaust manifold with the provided gaskets and hardware. (Parts used #2, 38, 56)

3-6 Oil Pressure Line Installation 1. In stall the oil pressure fitting to the block. Install the three way fitting between the b

3-7 Oil Return Line Installation 1. Wrap the oil return hose with the provided thermo cloth and install the hose from the turbocharger

3-9 Catalytic Converter Installation 1. Install the factory catalytic converter to the down pipe. 3-10 Heatshield Installation 1.

3-12 Suction Pipe Installation 1. Install the Airinx adapter on to the Airinx filter housing. (Parts used #8, 9) 2. Install the S-1 to the

3-14 E-manage Installation 1. Wire in the E-manage to the factory ECU. Important! Make sure to solder all the wires in except for the wires that h

3-15 Starting the Engine (1) Refill the engine oil to factory spec. (2) Check all the hoses and wires connection, then reconnect the negative side

e-manage Information Important! • The e-manage included in this kit is preprogrammed for the this turbo kit. • Do not attempt to adjust any of the

Checking Error Code Chart Incorrect wiring or disconnected Airflow Signal 1Airflow Signal 1input errorAirflow voltageoutput errorNo In

96-98 Nissan 240SX S14 (KA24DE) TD06-20G 8cm2 Installation Manual Please read the entire manual before installing this kit. Application: Make

1. Parts list 1. Turbocharger TD06-20G 8cm2 P380 1 2. Exhaust manifold (Cast Ductile Iron) 1 3. Downpipe (60∅ steel) 1 4. Compr

1. Parts list 33. Compression Pipe C-3 Bracket 1 34. Heatshield Bracket A 1 35. Heatshield Bracket B 1 36. Heatshield 1

1 2 3 4 5 6 7 8 9 10 11 12 - 13 14

15 16 17 18 19 – 21 22- 26 27 - 32 33 34 35 36 37 38 - 40 41 42 43 44

45 46 47 48 50 51 52 53 54 – 62

2. Removal of Stock Parts When removing the stock parts, make sure you read over the factory repair manual for proper procedures. 2-1 Disconnect

3. Kit Installation 3-1 Oil pan modification 1. Clean the oil pan. 2. Install the oil return pipe using the provided spacer as shown. 3. M