GReddy Turbo Kit HONDA Civic Si FG2 (K20Z) T517Z 8cm2
3. Kit Installation 3-1 e-Manage Ultimate Installation (1) Disconnect the ECM harness and remove the ECM. (2) Connect the E-manage Ultimate Plug
3-2 Thermo Cloth Installation (1) Wrap the thermo cloth to the engine harness, e-manage Ultimate harness, the heater hoses, and brake lines by the
3-4 Oil Pressure Line Installation (1) Remove the Oil Pressure switch and install the union fitting and 3-way fitting on to the block. * Use
3-6 Turbocharger Installation (1) Wrap the thermo cloth the actuator as shown. * The heat off the manifold can damage the actuator with out the the
(4) Install the Oil return hose bracket to the block and secure the hose to the bracket using provided zip ties as shown. (Parts used #61, 65) (5
3-10 Horn Installation (4) Install the horn using provided aluminum spacer as shown. (Parts used #66,77) 3-11 Compression Pipe Installation
(4) Install compression pipe C-5~ C-8 between intercooler and throttle body. Using provided hose and clamps. (Parts used #11,12,13,14,34,36,37,4
(7) Install the S-1. Secure the suction pipe bracket to the factory air cleaner box mounting point as shown. (Parts used #5,35,42,71) (8) Install th
(3) Install the downpipe to the turbo using provided gasket and hardware. *Make sure that there is enough clearance between the downpipe and
(2) Remove the injector clips off the rail, and remove the injectors. (3) Install the new injectors on to the rail. * Lube the o-rings on th
HONDA Civic Si FG2 (K20Z) T517Z 8cm2 Installation Manual Please read the entire manual before installing this kit. Application: Make
3-17 Starting the Engine (1) Refill the engine oil to factory spec. (2) Check all the hoses and wires connection and reconnect the battery. (3) Tu
e-manage Ultimate Information Important! • The e-manage included in this kit is preprogrammed for this turbo kit. • Do not attempt to adjust any of
1. PARTS LIST 1.Turbocharger T517Z 8c ㎡ P565 1 2.Exhaust manifold (Cast Ductile Iron) 1 3.Downpipe (Cast Ductile Iron,
34.Silicone Hose 50φ×70mm Straight 5 35. 〃 60φ×70mm Straight 1 36. 〃 50φ-60φ Reducer 3 37. 〃 60φ-65φ Reducer 1 38.
69.M6×10 P=1.0 Stainless B S/W F/W - (Down pipe Heatshield) 2 70.M6×15 P=1.0 Stainless B S/W - - (Oil Return・Heatshield) 4 71.M6×1
1. PARTS LIST 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
21 22,23 24 25 26 27 28 29 30~33 34,35 36~38 39~44 45 46 47 48 49 50 51 52
53 54 55 56 57 58 59 60 61.62 63 64 65 66、67 68~82 R L
2. Removal of Stock Parts When removing the stock parts, make sure you read over the factory repair manual for proper procedures. 2-1 Remove
Commentaires sur ces manuels